I have been there.
And they apply solutions that do not address the problem permanently.
I researched a bit and implemented a few of the tricks on my SteamVR.
I managed to find out the best methods toresolve the 108 error for good.
The primary reason behind error code 108 is improper connectivity.
If the connection between the VR and your PC is weak, you will likely get the error.
What would it take to resolve these simple reasons?
Nothing complicated, that I can assure you.
Keep reading the rest of the article to figure out.
How to Fix SteamVR Error 108- Headset not Detected?
Before executing the following solutions, it would be wise for you to start your rig.
Then after that, recheck every cable that is plugged in.
If everything seems alright, it’s possible for you to proceed to the next chapter.
You may also like to read:Steam Not Working on WiFi.
So, skipping theLinkboxwont do any harm if you attempt to bypass the connection, right?
If not, jump to the following methods.
Note:Try using USB 3.0 ports instead of USBhow 2.0 as they provide better speed.
After completing every listed step, find out if the issue persisted.
Try the following methods if the answer is yes.
Related content you should read:SteamVR not Recognizing Oculus Quest 2.
Launching Steam with administrative permission allowschanges to certain aspects of your operating system.
If any bugs or glitches are harming you, this might bring out the best possible output.
Heres the process to run Steam as an administrator:
Open theTask Managerand end all processes related to Steam.
After that, launch the VR and check the error 108 still exists.
If you are using the beta version of Steam you are likely to encounter various error messages includingerror 108.
Opt-out of the beta version to avoid such problems.
Check out our separate post on how toCalibrate Steam VR.
Reinstating the SteamVR program will help you by eliminating unnecessary tweaks of the program.
Here are the steps to re-install SteamVR:
Your problems should be gone after implementing this method.
Dont panic if the issue hasnt been resolved yet.
I have still some tricks left.
Keep your patience as you have done so far and continue reading.
For the final method for you to try, I would recommend you enable direct mode on your SteamVR.
This might seem a simple solution, but trust me, this is worth trying.
Which is very unlikely.
My final recommendation would be to reach out to the manufacturer immediately.
These solutions are tested and verified.
If the hardware of your headset is functional, these methods will handle the matter.
If that does not, drop a line to the manufacturer and describe your issue.
They will take the matter in hand afterward.
Also read, how toFix Steam Link Setup: No Host Computers Found.
Connect the headset to your dedicated graphics driver.
But then again, if you run into any obstacles applying those methods, feel free to comment below.
