Are you trying to scale the steam VR area according to the available space of your room?
Or calibrate the optimal measurement?
Well, you are in the right place.
The calibration process can be challenging if you are new to Steam VR.
Do you want to know more about the calibration process?
Stop roaming around and read this article from top to bottom.
Once you read the whole passage, I am sure all of your confusion will be cleared out.
The first one is room calibration.
Guess what did that occur!
That wasnt supposed to happen only if I measured the clear area and input that into the VR headset.
But, you dont know how to do that?
Read the following instruction carefully and act accordingly.
Whenever you play a new game, boundaries are needed to set up according to the game.
But, you’ve got the option to avoid the hassle by implementing some primary rules.
Those are given below:
If you have guaranteed those primary stages, proceed to the next step.
Base stations range the room with multiple pulses and/or laser lines.
Cable management is the key to configuring the VR appropriately.
There are some important things to remember while wiring up.
Connect with the internet.
If its in gray, repeat the previous steps and proceed to the following action.
Before reaching the floor measurement, point either one of your controllers toward the monitor.
Press and hold the trigger button while you are pointing to the monitor.
This will set the height parameter in your SteamVR.
This process will set the lowest height.
Do not hold the controllers over floor level.
Now that you have set the roaming area, its time to introduce that area to your Steam VR.
Note:Avoid every little object that you think you could overstep.
Dont get too close to any objects when you mark them up.
After you trace the play area successfully, you shall notice a green box on the SteamVR interface.
That box is the boundary wall of your play area.
If the space is not sufficient, the box will be red colored.
If that occurs, double-check you free up more space.
And work from the beginning steps.
This is by far the easiest and most efficient process to calibrate your room for Steam VR.
Just connect the VR headset to your system and perform the following steps.
Calibrate the SteamVR Thumbstick Angle
you might adjust the thumbstick angle using steam VR beta.
If your controllers thumb angle is not properly set up, you might try this trick.
Turn on your headset and follow the steps.
If you pet any animals, dont even let them enter into the measured area.
You will be able to calibrate with the skills you already have.
But, then again, if you face any difficulties calibrating the VR, feel free to comment below.
I will be happy to help you.
